i am using IC 6.1.5-64b with foundary file of UMC-180nm. i want to use monto carlo mis match simulation to find the gain of folded cascode op amp.
in ADE-Xl after setup the test ,i include montocarlo model file(with extension of mc-corner.scs) after that l loaded the saved state and i also defined the variable sigma value of 3.
after i click on the run button it showing finished .but when i click on the plot button it shows nothing...
in cds.log file i found the following information
You must openResults() on a valid psf directory before
using this command. Make sure your openResults() worked.
Use ocnHelp('results) for more information.
in ADE-Xl after setup the test ,i include montocarlo model file(with extension of mc-corner.scs) after that l loaded the saved state and i also defined the variable sigma value of 3.
after i click on the run button it showing finished .but when i click on the plot button it shows nothing...
in cds.log file i found the following information
You must openResults() on a valid psf directory before
using this command. Make sure your openResults() worked.
Use ocnHelp('results) for more information.