ADEXL Parametric Set Simulation

Hi,
I am trying to run a parametric set simulation in ADEXL, but i cannot do it. Basically i have Two variables, but i would like to control the sweep as shown below:
A = [1 2 3]
B = [4 5 6]
I would like to run only 3 simulations
1)A=1,B=4
2)A=2,B=5
3)A=3,B=6
However, currently ADEXL will perform 9 simulations, simulating each of the settings for set A against all options in set B. I know in ADEL there is a way to do this, but i was wondering if there is a way to do this in ADEXL.

Thank you,
Shayan